Table of Contents
Advertisement
Your AutoSampler or AutoInjector will execute the desired injection.
To set up an automated series of injections, simply complete the
following steps:
1. Press the Automation Select/Edit button on the CP-3800, choose
2. Press the Automation Select/Edit button again and press 2 to
3. Place your samples into the AutoSampler carrousel.
4. Press the Start button.
This manual will cover AutoSampler installation, software setup and
calibration to the correct sampling and injection positions, a description
of the operating parameters, and some examples of how you may wish
to use the CP-8400/8410 to accomplish your analyses. If, after reading
this manual you still have questions or encounter a problem that is not
covered, please contact Technical Support for further assistance.
2
either Single Method automation to run all of your samples with a
single method, or choose Method Sequence Automation to run
specific methods with specific vials.
select Single Method, or 3 to select Method Sequence and enter
the methods you wish to use, the vial range, the amount you
want to inject and the injector you wish to use (if you have more
than one injector installed).
03-914852-00:4
Hide quick links:
Advertisement
Table of Contents
