Ellipsoidal Reflector - Philips VARI-LITE VL4000 Spot Service Manual

Ellipsoidal Reflector

Vari-Lite Part No: 42.9704.0150
To replace ellipsoidal reflector:
Step 1. Remove reflector assembly following the procedure described in
page
Step 2. Loosen 4 x 6-32 x 3/16" PPZ screws, pivot retainer clips and remove reflector.
Note:
Drawing exploded and some
components removed for clarity.
Note: Align ridge on reflector with clip at notched position of assembly. This part changed. Older
units have a tear drop cutout. Current models have just a slight elongation. These notes are for current
reflector. For old reflector align mark to clip above the notched position of assembly (see drawings).
Before reassembly, be sure to clean any dirt, finger prints, etc. from reflector assembly.
Step 3. Replace in reverse order.
02.97 04.001 0 A
Note: All procedures are done with the power completely removed. Adhere to all warnings in this manual.
73.
Retainer Clip Screw (x4)
Ellipsoidal Reflector
S P : E
ERVICE ROCEDURES
See note below
R
LLIPSOIDAL EFLECTOR
"Reflector Assembly" on
Retainer Clip (x4)
2
75