Table of Contents
Advertisement
PROCESSOR TECHNOLOGY CORPORATION
CUTS, COMPUTER USERS TAPE SYSTEM
SECTION II
2.1
PARTS AND COMPONENTS
Check all parts and components against the "Parts List"
(Table 2-1 on Page 11-2).
If you have difficulty in identifying
any parts by sight, refer to Figure 2-1 on Page 11-3.
2.2
ASSEMBLY TIPS
1.
Scan Section II in its entirety before you start to
assemble your CUTS kit.
2.
In assembling your CUTS, you will be following a step-
by-step assembly procedure.
FOLLOW THE INSTRUCTIONS IN THE ORDER
GIVEN.
3.
Assembly steps and component installations are pre-
ceded by a set of parentheses.
Check off each installation and
step as you complete them.
This will minimize the chances of
omitting a step or component.
4.
When installing components, make use of the assembly
aids that are incorporated on the CUTS PC board and the assembly
drawing.
(These aids are designed to assist you in correctly in-
stalling the components.)
a.
The circuit reference (R3, C10 and U7, for example)
for each component is silk screened on the PC board
near the location of its installation.
b.
Both the circuit reference and value or nomenclature
(1.5K and 74LS08, for example) for each component
are included on the assembly drawing near the loca-
tion of its installation.
5.
To simplify reading resistor values after installation,
install resistors so that their color codes read from left-to-right
and top-to-bottom as appropriate (board oriented as defined in Para-
graph 2.5 on Page 11- .)
6.
Unless specified otherwise in the instructions, install
components--especially disc capacitors--as close to the board as
possible.
7.
Should you encounter any problem during assembly, call
on us for help if needed.
11-1
Advertisement
Table of Contents
