Processor Technology CUTS Assembly And Test Instructions page 56

PROCESSOR TECHNOLOGY CORPORATION
CUTS, COMPUTER USERS TAPE SYSTEM APPENDIX III
(3) Check for solder bridges.
(4)
Remove carrier.
To install single pins, proceed as follows:
(1)
Hold board between two objects so that it stands on edge.
(2)
Insert pins in the mounting holes from front (component) side
of board.
(3)
Solder pins from back (solder) side of board so the solder
"wicks Up" to the front side. (This will hold the pins firm-
ly in place.)
(4)
Insert a component lead into one pin and reheat the solder.
Using the component lead, adjust pin until it is perpendicu-
lar to board. Allow solder to cool while holding the pin as
steady as possible. Remove component lead. Repeat this
procedure with other pins.
If cooled solder is mottled or crystal-
lized, a "cold joint" is indicated, and
the solder should be reheated.
(5)
Check each installation for cold joints and solder bridges.
AIV-3