Table of Contents
Advertisement
CUTS
(Applies only to Rev B and below
circuit boards)
ASSEMBLY PROCEDURE CHANGE NOTICE #2
Rev B and below CUTS circuit boards have an error that was intro-
duced during their manufacture:
A trace was connected to pin
8
of
Ull which shorts the voltage controlled oscillator (VCO) output on
pin 4 of Ull to ground.
CORRECT THIS ERROR AS SHOWN BELOW BEFORE
YOU CHECK THE BOARD AND START ASSEMBLY.
Cut this trace to Pin
8
of Ull to break
Ull-4 to ground connection.
UIO
I I I I I I I I II I I
Solder
(Back)
Side of
Board
PROCESSOR TECHNa.oGY CORPORATION 6200 HOLLIS STREET EMERYVILLE CA 94608
(415) 652-8080
CABLE ADDRESS "PROCTEC"
Advertisement
Table of Contents
