Table of Contents
Advertisement
PROCESSOR TECHNOLOGY CORPORATION
CUTS, COMPUTER USERS TAPE SYSTEM
SECTION III
To select the microphone output to drive the microphone in-
put to an audio cassette recorder, install a jumper (#24 bare wire
is recommended) between Augat pins A and C.
3.4
DATA RATE SELECTION
Your CUTS is presently wired for both 1200 and 300 Baud
operation, with the selection being program controlled.
CUTS is
designed, however, for operating at data rates up to 9600 Baud.
The
pad labeled AA, K, L, Q, R, S, T, U, V, W, X, Y and Z are provided
for increasing the data rate.
How the board is configured for
higher rates will be the subject of a future addendum to this
manual.
At this point in time Processor Technology does not recom-
mend operation higher than 1200 Baud.
111-2
Advertisement
Table of Contents
