Table of Contents
Advertisement
CUTS
MANUAL
ERRATA
SHEET
#1
Reference Step 23 on Page 11-17
The sixth paragraph should read as follows:
( ) Measure the DC voltage at pin 9 of Ull and write the
measured voltage down.
(Call this Voltage A.)
The eighth paragraph should read as follows:
( ) Measure the DC voltage at pin 9 of ull and write the
measured voltage down.
(Call this voltage B.)
MAKE THESE CORRECTIONS IN YOUR MANUAL BEFORE YOU START TO ASSEMBLE
YOUR
CUTS
MODULE.
ESl-3/77
PROCESSOR TECHNOlOGY CORPORATION
6200 HOllIS STREET EMERYVillE CA 94608
(415) 652-8080
CABlE ADDRESS "PROCTEC"
Advertisement
Table of Contents
