Allied Telesis 29M2/SP-BA Installation And User Manual page 27

2. Remove the cover of your system by using the Phillips-head
screwdriver. See Figure 3.
3. While holding the sides of the chassis with your hands, slide the cover
using your thumbs to open the system. See Figure 4.
4. Remove the 2.5 inch hard drive bay if present.
5. Remove any back plate or previously installed device that is occupying
the back of the SFP cutout if necessary. See the Figure 5 on page 28.
6. Remove an M.2 device, such as a Wi-Fi card, if any. See Figure 5 on
page 28.
Warning
When removing a Wi-Fi card, secure the antenna wires so that they
do not come in contact with the system motherboard.
Figure 3. Removing the Cover
Figure 4. Opening the System
Chapter 2: Installing the Hardware
27