Description; Sfp Slot; Led - Allied Telesis 29M2/SP-BA Installation And User Manual

29M2/SP-BA Fiber Network Adapter Installation and User's Guide

Description

The 29M2/SP-BA fiber network adapter is interface boards connected with
a ribbon cable designed to be installed into the Dell OptiPlex 50x0 and
70x0 systems.
The 29M2/SP-BA fiber network adapter is equipped with an SFP slot to
add a fiber connection to the Dell systems.
After physically installing the 29M2/SP-BA fiber network adapter in the
system, start your Windows 10 and install driver software. To install driver
software, see Chapter 3, "Installing the Driver Software" on page 35.
Figure 1 shows the 29M2/SP-BA fiber network adapter.
Controller board
Ribbon cable
SFP board
Figure 1. 29M2/SP-BA Fiber Network Adapter

SFP Slot

The 29M2/SP-BA fiber network adapter has an SFP slot that you can plug
in an SFP transceiver to connect the system to a compatible link partner.
The link connected through the SFP slot operates at either 100Mbps or
1000Mbps (depending upon the speed of the installed SFP) and only in
full-duplex mode.

LED

The 29M2/SP-BA fiber network adapter comes with one LED as shown in
Figure 2. The LED indicates the link and activity status of the port.
LED
Figure 2. LED
14