Table of Contents
Advertisement
2914 Series Fiber Network Adapters with WoL Installation and User's Guide
Description
16
The 2914 fiber network adapter series is a 100/1000Mb Ethernet PCI
Express (PCIe) card equipped with one fiber optic port or SFP slot. The
AT-2914GP/SP model comes with one copper port with Power over
Ethernet (PoE) capability in addition to the SFP fiber slot.
The 2914 network adapters support the Wake-on-LAN (WoL) feature.
WoL is a protocol for remotely turning on a computer in a low power mode
with a network message. A magic packet is a network message that a
WoL-enabled computer receives and wakes up when the computer's MAC
address matches one in the magic packet.
The AT-2914SX/SC and AT-2914SX/LC models are Gigabit Ethernet
network adapters operating at 1000Mbps. The AT-2914SP and
AT-2914GP/SP models can operate at 100Mbps or 1000Mbps depending
on the SFP type in use. The copper port on the AT-2914GP/SP model can
operate at 10, 100, or 1000Mbps.
If you installed the network adapter on your Windows platform, you must
install network adapter driver software. For instructions, see Chapter 3,
"Installing the Driver Software" on page 43.
Note
You do not need to install network adapter driver software for Linux
systems because Linux has inbox drivers for the network adapters.
Figure 1 shows the AT-2914SX/SC model.
Figure 1. AT-2914SX/SC Network Adapter
Advertisement
Table of Contents
