Step 2 - Mounting Brackets - Smith & Noble Solar & Roller Shades Step By Step Installation Instructions

STEP 2 - MOUNTING BRACKETS

Inside Mount Loop Control
with Metal Valance
The installation brackets are always
mounted so that the short legs face in .
Brackets must be in line and level . Shim
brackets on inside mounts if necessary .
The roller must be level for the shade to
operate properly .
Hold the left shade in the window
frame. Mark the position of the square
end bracket. Attach the square end
bracket using two screws through the
top of the bracket. The square end
bracket should be installed with the
open end down .
Hold up the next shade positioning
the left end into the installed square
end bracket and mark position of
intermediate bracket . The spring pin
end should compress half way for best
fit. Install the intermediate bracket
using both screws making sure it is
aligned with other installed brackets .
Hold the right shade in the window
frame. Mark the position of the square
end bracket. Attach the square end
bracket using two screws through the
top of the bracket. The square end
bracket should be installed with the
open end down .
Make sure all brackets are aligned and
installed following the proper bracket
configuration (Page 16). Brackets
should be top mounted for proper
alignment .
smithandnoble.com
15
INSIDE MOUNT
STEP 2 - MOUNTING BRACKETS
OUTSIDE MOUNT
BRACKET CONFIGURATION
Left Shade Right Shade
Left Shade Middle Shade Right Shade
Outside Mount Loop Control
with Metal Valance
The end installation brackets are always
mounted so that the short legs face in .
Brackets must be in line and level . The
roller must be level for the shade to
operate properly .
Hold the left shade above the window
so that it's positioned in the desired
location over the window opening .
Mark the position of the square end
brackets on the wall. Mount the square
end bracket to the wall using both
screws. The square end bracket should
be installed with the open end down .
Hold up the shade positioning the
left end into the installed square
end bracket and mark position of
intermediate bracket . The spring pin
end should compress half way for best
fit. Install the intermediate bracket
using both screws making sure it is
aligned with other installed brackets .
Hold the right shade up and mark the
position of the square end bracket.
Attach the square bracket using two
screws. The square bracket should be
installed with the open end down .
Make sure all brackets are aligned and
installed following the proper bracket
configuration (below).
800.248.8888
16