Smith & Noble Solar & Roller Shades Step By Step Installation Instructions page 19

ADD OR REMOVE REMOTE OR CHANNEL
To De-Activate the Jog Function
The remote comes pre-set with jogging
function activated. Follow the directions
below if you would like to de-activate it.
1. Press down and up on the back cover to
slide it approximately / inch.
1
4
2. Carefully remove the back cover of
the remote.
3. Slide the switch from the H position to
the R position.
4. Replace the back cover of the remote
making sure that the rubber piece that
goes over the confirm and limit buttons
stays in place.
35 smithandnoble.com
REMOTE BACK
H R
REMOTE BACK
SHADE MOTOR
CHARGING PORT SETTING
BUTTON
INSERT
CHARGER
REPLACE BATTERY IN REMOTE
BACK OF FRONT OF
REMOTE REMOTE
ACCESS
DOOR
BATTERY
TRAY
CHARGING SHADE
When the shade begins to operate slower
than normal it is time to charge the battery.
Plug the 8.4v charger into the port on the
motor.
Plug the charger into an electrical outlet. A
red light on the charger indicates that the
battery is charging.
To fully charge the batteries, allow the
batteries to charge for at least 1 hour after
the light on the charger turns green. A typical
charge cycle can take between 4-6 hours.
Do not leave the charger plugged in for more
than 24 hours. This could prematurely age the
battery.
CHARGER
Replacing The Battery In The Remote
Remove the battery tray from the remote by
inserting a fingernail into the indentation on
the back of the remote. To avoid the battery
falling out of the remote, remove the tray
while the remote is face up.
Insert the new battery (CR2430 lithium) into
the battery tray so that the writing is facing
up (positive up) when the remote is face up.
Slide the tray back into the remote.
800.248.8888
36