Smith & Noble Solar & Roller Shades Step By Step Installation Instructions page 18

UNPAIR THE REMOTE
To unpair a shade(s) from a selected channel,
press and release the CONFIRM button on
the back of the remote.
Continue to press & release until the shade
jogs & beeps.
Please note: All shades assigned to the selected
channel will be unpaired during this process.
DISABLING UNUSED CHANNELS
The 14 channel remote has the option
of turning off unused channels, making
channel selection easier.
Press and hold both UP and DOWN
buttons for 3 seconds until 00 Channel
displays. Release the buttons and the 00
will start to flash.
Press the UP or DOWN button to
select the required number of channels
(between 1-14).
Press and hold the CHANNEL and RAIL
selector buttons at the same time to
confirm selection. The display will go
back to channel 01.
Follow the same process if you need to
re-add channels.
NOTE: 00 will only show the first time
you disable unused channels. After that,
the display will flash with the number of
active channels set to the remote.
33 smithandnoble.com
LIMIT
BUTTON
CONFIRM
BUTTON
REMOTE BACK
CHANNEL
DISPLAY
UP
STOP/
FAVORITES
DOWN
CHANNEL
RAIL
SELECTOR
REMOTE FRONT
ADD OR REMOVE REMOTE OR CHANNEL
Replace Original Remote, Add Additional
Remote or Add Shade to an Additional
CHANNEL
Channel
DISPLAY
1. Press the SETTING button on the motor
UP
STOP/
FAVORITES
DOWN
CHANNEL
RAIL
2. Select the channel that you want to add
SELECTOR
3. Press and hold the CONFIRM button until
REMOTE FRONT
4. Repeat steps 1-4 to add the rest of the
Remove a Shade from a Remote or
Channel and Pair it to a Different
Remote or Channel
1. Select the channel that you want to unpair.
2. Press and hold the CONFIRM button on
3. Press the SETTING button again on the
LIMIT
BUTTON
CONFIRM
BUTTON
4. Select the channel that you want to add
5. Press and hold the CONFIRM button until
REMOTE BACK
6. Repeat steps 3-5 to program the rest of the
until the shade jogs & beeps once.
Release the button immediately after the
first jog & beep - this should not be more
than 3 seconds. Repeat this step for all
shades that will be controlled by a single
channel button.
using the CHANNEL selector button.
the shade(s) jogs & beeps.
channels on a multi-channel remote.
the back of the remote. Continue to press
& release until the shade jogs & beeps.
The original remote or channels have been
unpaired.
motor until the shade jogs & beeps. Release
the button immediately after the first jog
& beep - this should not be more than 3
seconds. Repeat this step for all shades that
will be controlled by a single channel.
using the CHANNEL selector button.
the shade(s) jogs & beeps.
channels on a multi-channel remote.
800.248.8888
34