Smith & Noble Solar & Roller Shades Step By Step Installation Instructions page 17

SETTING SHADE LIMITS
Hold the LIMIT button until the shade jogs
& beeps.
Lower Limit
Use the DOWN button to lower the
shade. Press stop when the shade is near
the desired lower limit.
WARNING
: The motor will not stop until
the STOP button is pressed. If the shade
is not stopped, the motor will continue to
work past the operable limit and will cause
damage to the shade.
Use the UP and DOWN buttons to adjust
the length more accurately.
Hold the CONFIRM button until the shade
jogs & beeps. This locks in the lower limit.
Upper Limit
Use the UP button to raise the shade.
Press stop when the shade is near the
desired upper limit.
WARNING
: The motor will not stop until
the STOP button is pressed. If the shade
is not stopped, the motor will continue to
work past the operable limit and will cause
damage to the shade.
Use the UP and DOWN buttons to adjust
the upper limit more accurately.
Hold the CONFIRM button until the shade
jogs & beeps. This locks in the upper limit.
Note: If you also desire to set a favorite
position you should do so prior to
turning on or re-pairing other shades on
that channel. See SETTING & USING A
FAVORITE POSITION.
31 smithandnoble.com
CHANNEL
DISPLAY
UP
STOP/
FAVORITES
DOWN
CHANNEL
RAIL
SELECTOR
REMOTE FRONT
LIMIT
BUTTON
CONFIRM
BUTTON
REMOTE BACK
SETTING & USING A FAVORITE POSITION
If there is only a single shade on the channel
proceed to SETTING A FAVORITE POSITION
below.
CHANNEL If there is more than one shade on the channel, all
DISPLAY
shades on that channel will need to be unpaired
(see UNPAIR THE REMOTE) or turn the motor off
using the ON/OFF switch.
UP
Follow the steps in PAIR THE REMOTE
STOP/
the shade
FAVORITES
proceed to SETTING A FAVORITE POSITION.
DOWN
Setting a Favorite Position
CHANNEL
RAIL
Use the UP or DOWN buttons to position the
SELECTOR
shade at the desired "favorite" position. While
holding the LIMIT button, quickly press and hold
the UP button. Release both buttons when the
shade jogs & beeps.
REMOTE FRONT
When complete, re-pair previously unpaired shades
by following the steps to PAIR THE REMOTE or
turn the motor on using the ON/OFF switch.
Using a Favorite Position
With the shade at either the upper or lower limit,
simply press the STOP/FAVORITE button to bring
the shade to the "favorite" position. To go to the
"favorite" position from any other location, make
sure the shade has been stopped for at least three
LIMIT
seconds before pressing the STOP/FAVORITE
BUTTON
button.
CONFIRM
Changing a Favorite Position
BUTTON
Use the UP or DOWN buttons to position the
shade at the desired "favorite" position. While
holding the LIMIT button, quickly press and hold
REMOTE BACK
the UP button. Release both buttons when the
shade jogs & beeps.
SHADE MOTOR
To erase a "favorite" position, bring the shade to
the upper limit. Press and hold the LIMIT button
on the back of the remote, then press and hold
the UP button. Release both buttons when the
ON/OFF
SWITCH
shade jogs & beeps.
When complete, re-pair previously unpaired shades
by following the steps to PAIR THE REMOTE.
CHARGING SETTING
PORT BUTTON
to pair only
that needs a favorite position set. Then
800.248.8888
32