OVERVIEW STEP 1 — PARTS & TOOLS Motorization Getting Started First, make sure you have all the parts and tools required to install your shades . ALL THE HARDWARE YOU’LL NEED: HEADRAIL Pencil, screw-driver, ¼” nut driver, level, and a drill with a ⁄...
STEP 2 — MOUNTING BRACKETS STEP 2 — MOUNTING BRACKETS 3" Inside Mount Outside Mount 2 ¼" MINIMUM DEPTH NEEDED TO FULLY RECESS SHADE TO WALL . 2¼" Hold the shade inside the window frame The minimum mounting height for so that the front edge of the shade and outside mounted shades is 7 ⁄...
STEP 3 — HANGING & REMOVING THE SHADE STEP 2 — MOUNTING BRACKETS Hanging the Shade Spacer Blocks - Outside Mount Before mounting the headrail make (Optional) sure that the receiver wire is out of the headrail . For optimal performance Each spacer blocks projects brackets position the receiver wire so that it is ⁄...
STEP 5 — OPERATING THE SHADE STEP 4 — LINK THE REMOTE CONTROL Remote Control Link the Remote Control For added protection, your remote control The remote control has multiple arrived with a protective film on the top . channels . Before linking the remote, Please remove this film prior to use .
Page 7
STEP 6 — ADJUST MOTOR LIMITS STEP 6 — ADJUST MOTOR LIMITS (if desired) (if desired) Remote Control Lower Limit The lower and upper limits have been Hold the LIMIT button until the shade set at the factory . If you need to make starts beeping .
SETTING & USING A FAVORITE POSITION ADVANCED PROGRAMMING Remote Control Replacing Original Remote, Adding Additional Remote or Adding If there is only a single shade on the channel, Shade(s) to an Additional Channel proceed to setting favorites below . If there is more than one shade on the 1 .
REPLACING THE BATTERY, CHARGING MOTOR LEVEL THE BOTTOM RAIL, HOLD DOWN BRACKETS Remote Level the Bottom Rail ADJUSTMENT ADJUSTMENT Remove the battery tray from the remote SCREW SCREW by inserting a fingernail into the indentation Honeycomb Shades use a system that on the back of the remote .
CARE & CLEANING AND SAFETY TROUBLESHOOTING Care & Cleaning Problem Solution Minimal care and cleaning is needed to maintain the beauty of your shades . The motor does not work Recharge motor . To Vacuum: Use a hand-held vacuum with low suction for a more thorough cleaning to keep your shades looking fresh and neat .
Warranty Service The enjoyment of your window coverings should be everlasting, which is why our products come with a limited lifetime warranty . The warranty applies to the original owner, requires a proof of purchase and covers defects in material or craftsmanship .