Step 3 - Hanging The Shade; Overview - 2 On 1 Loop Control With Metal Valance - Smith & Noble Solar & Roller Shades Step By Step Installation Instructions

STEP 3 - HANGING THE SHADE

Hanging Shades without
Headrail
Once the brackets are secured and
level, the fabric roll can be inserted.
Make sure your hands are clean to
avoid soiling the fabric .
Be sure the motor and roller end plug
are inserted into the roller . Hold the
shade with the bottom of the motor
facing the floor. Be sure the shade is
fully rolled on the tube .
Insert the spring loaded pin end into
the round hole of the bracket .
Push the motor end toward the pin
end to compress the spring . The pin
should compress half way in for best
fit. Line up the hooks on the motor
with the two slots in the bracket .
Allow the spring to release and let
the hooks go into the slots .
Once the two hooks are through the
slots, gently pull down on the motor
until the hooks lock securely to the
bracket .
Bracket covers come standard
for outside mount shades and if
requested for non-flush inside
mounted shades . If your shade came
with bracket covers, slide the bracket
covers over the bracket until they
snap into place .
smithandnoble.com
13
No Headrail
OVERVIEW - LOOP CONTROL - METAL VALANCE
END CENTER
BRACKET BRACKET
Parts
BRACKETS FOR SHADES
SCREWS WITH METAL VALANCE
METAL VALANCE
HOLD DOWN BRACKET
BRACKET COVER
(OPTIONAL)
(OUTSIDE MOUNT ONLY)
Loop Control – with Metal Valance
END
METAL
VALANCE BRACKET
BOTTOM
BARS
INTERMEDIATE
METAL VALANCE MOUNTING BRACKET
BRACKET COVER
(OUTSIDE MOUNT ONLY)
METAL VALANCE CLIP
800.248.8888
CORD
TENSIONER
14