STEP 1 - PARTS & TOOLS OVERVIEW Motorizati on with Remote Control Getti ng Started First, make sure you have all the parts and tools required to install your shades. CASSETTE ALL THE HARDWARE YOU’LL NEED: Pencil, screw-driver, ¼” nut driver, level, and a drill with a ⁄...
STEP 2 - MOUNTING BRACKETS STEP 2 - MOUNTING BRACKETS Outside Mount Shadings are shipped with the required number of brackets for proper installation. End brackets should be located approximately 3" from either end. Depending on the width Center the shading over the window 1"...
STEP 3 - HANGING THE SHADE STEP 4 - HOLD DOWN BRACKET Hanging the Shade Attaching Hold Down Bracket (Optional) With brackets installed, place the top of Lower the shading, keeping the vanes closed. Bottom the headrail flat against the base of the Rail •...
• Test and, if necessary, adjust again. If these suggesti ons don’t work, then please give us a call or visit our website. Weight Clip Weight Clip Weight Fabric Roll Move Weight Release Roller & Solar Shades Sheer Shadings smithandnoble.com...
PAIRING THE REMOTE PAIRING THE REMOTE Pair The Remote For added protecti on, your remote control arrived with a protecti ve fi lm on 1. Select the channel that you want to top. Please remove this fi lm prior to use. pair the shades to, using the CHANNEL Your shades will need to be paired to the selector butt on.
OPERATING THE REMOTE SETTING SHADE LIMITS Adjust Shade Limits (If Desired) Select the desired channel with the CHANNEL butt on. The lower and upper limits have been set at CHANNEL CHANNEL the factory. If you need to make adjustments Raise and Lower Shade DISPLAY DISPLAY to the limits, follow the instructi ons below.
Page 9
SETTING SHADE LIMITS SETTING & USING A FAVORITE POSITION If there is only a single shade on the channel Hold the LIMIT butt on unti l the shade jogs proceed to SETTING A FAVORITE POSITION below. & beeps. CHANNEL CHANNEL If there is more than one shade on the channel, all Lower Limit DISPLAY...
UNPAIR THE REMOTE ADD OR REMOVE REMOTE OR CHANNEL To unpair a shade(s) from a selected channel, Replace Original Remote, Add Additi onal press and release the CONFIRM butt on on Remote or Add Shade to an Additi onal the back of the remote. CHANNEL Channel DISPLAY...
Page 11
ADD OR REMOVE REMOTE OR CHANNEL CHARGING SHADE When the shade begins to operate slower To De-Acti vate the Jog Functi on SHADE MOTOR than normal it is ti me to charge the batt ery. 1. The remote comes pre-set with jogging Plug the 8.4v charger into the port on the functi on acti vated.
SOLAR PANEL INSTALL SOLAR PANEL (OPTIONAL) Determine Solar Panel Placement Tape Method SOLAR PANEL RECHARGE UNIT The solar panel should be placed where it Cut the tape to fi t inside the white border gets the maximum amount of sunlight per as shown.
INSTALL SOLAR PANEL TROUBLESHOOTING Connect Solar Panel to Motor PROBLEM SOLUTION SHADE MOTOR After the shade is installed, plug the Shade will not raise or lower. Recharge motor. solar unit into the motor recharge port. Shade runs slowly. Recharge motor. The motor continues to run in The limit setting was unsuccessful and one direction.
CARE & CLEANING / SAFETY NOTES Care & Cleaning Minimal care and cleaning is needed to maintain the beauty of your shades. To Vacuum: Use a hand-held vacuum with low suction for a more thorough cleaning to keep your shades looking fresh and neat. To Dust: Use feather duster lightly over the vanes of the shade.
Warranty Service The enjoyment of your window coverings should be everlasting, which is why our products come with a limited lifetime warranty. The warranty applies to the original owner, requires a proof of purchase and covers defects in material or craftsmanship.