Step 4 - Attaching The Valance; Optional; Skew Adjustment; Hold Down Brackets - Smith & Noble Solar & Roller Shades Step By Step Installation Instructions

STEP 4 - ATTACHING THE VALANCE

Attaching the Valance
Insert a valance clip into the bottom front
keyhole slot of each bracket .
Press the bottom firmly to lock into place .
Hold the valance on the top of the bracket
first, and rotate downward.
Press until the bottom hook feature on
the valance engages and is locked to the
valance clip .
Bracket Covers - Outside Mount
Press the covers onto the brackets as
shown . Covers will snap in place .
Bracket Covers - Inside Mount
Snap or peel adhesive backing and stick
cover over exposed portion of installation
bracket .
23 smithandnoble.com
"L" portion of valance
Locked
Pull

Skew Adjustment

If the shade does not raise evenly,
first make sure the mounting brackets
are mounted level with each other .
If the shade is level and it still
skews, use the Skew Adjustment Kit
included with your shade to adjust
skewing .
If these suggestions don't work,
then please give us a call or visit our
website.
Hold Down Bracket
Optional Hold Down Brackets are
mounted with the supplied screws .
With the shade at its proper drop,
place the pin of each Hold Down into
the hole in each End Cap and make
sure the pins are level and aligned .
Mark the screw holes with a pencil .
Raise the shade, then screw the Hold
Down Bracket into the mounting
surface .

OPTIONAL

Fabric Roll
Place tape at this end
Hold Down
Bracket
800.248.8888
24