Display Of Flame Current Ion Or Qra; Reset - Siemens LME7 Series Basic Documentation
Burner control
Hide thumbs
Also See for LME7 Series:
- Technical instructions (140 pages) ,
- Basic documentation (165 pages) ,
- Manual (106 pages)
Table of Contents
Advertisement
Note:
This display is only possible in operating mode or standby!
+
+
1...3 s
+
>3 s
nfo
>1 s
Note:
For meaning of the error and diagnostic codes, see chapter Error code list...
Building Technologies Division
Infrastructure & Cities Sector
25.4.2
Display of flame current ION or QRA...
25.4.3
Reset
Basic Documentation LME7...
25 Operation via internal LED
+
Press
for display of the flame signal amplifier.
Signal lamp blinks green.
Display shows FL.1.
+
When pressing
(1...3 seconds), the flame signal
current is displayed.
Signal lamp blinks green.
Example: 11.
+
When pressing
(>3 seconds), the point after the
number begins to blink.
When the button is released, the value is displayed for 2
minutes.
Signal lamp blinks green.
Then, the normal display appears.
Display: Point . blinks, value 11 does not.
For reset the unit, press
When the button is released, OFF is displayed.
The basic unit is reset.
nfo
for 1...3 seconds.
207/245
CC1P7105en
29.11.2011
Hide quick links:
Advertisement
Table of Contents
