Table of Contents
Advertisement
Available languages
Available languages
CAUTION! Only trained personnel should be
allowed to operate or service this machine.
WARNING! Burn Danger – Switch off power,
unplug the dispenser and allow the top heater
to cool down before performing any cleaning,
maintenance or repair.
WEEKLY MAINTENANCE
1.
Wash the moistening brush with soap and warm
water. Rinse thoroughly with water.
2. Clean the dispenser using compressed air (NEVER
WATER) to clean off dust and dirt.
MONTHLY MAINTENANCE
1.
Lubricate the cutting blades with a drop of oil.
2. Clean the rubber tape advance wheel with water.
DO NOT grease or oil the wheel. Access the wheel
by removing the upper paper guide.
3. Clean the water reservoir with soap and water.
Rinse thoroughly.
4. Clean only the outside of the heater (close to the
brush) with a cloth dipped in decalcifying product.
5. To remove bigger deposits, use a very fine abrasive
cloth or thin blade– Do not scratch or damage the
surface.
6. Replace the heater if deposits cannot be removed
or after 3,500 hours of use.
PAGE 5 OF 18
MAINTENANCE AND CARE
HEATER CLEANING
WARNING! Burn Danger - Switch off power,
unplug the dispenser and allow the top heater
to cool down before attempting to clean
the heater.
CAUTION! NEVER use water or liquid to clean
the top heater.
0316 IH-1036
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the H-1036 and is the answer not in the manual?
Questions and answers
H 1036 tape doest stop dispensing and doesnt cut
The U-Line H-1036 tape may not stop dispensing and not cut due to incorrect setup or a malfunction. Possible causes include:
1. Tape not properly loaded.
2. Water bottle not filled or not installed correctly.
3. Top heater not installed or not functioning properly.
4. Malfunction in the control panel or dispensing mechanism.
5. Incorrect operation of the Random Length button.
Check installation of the tape, water bottle, top heater, and control settings to ensure proper function.
This answer is automatically generated