JCM GLOBAL TBV Series Integration Manual page 32

On-line Off-line
LED Color LED Color
(Flash (Flash
Sequence) Sequence)
Red Red
(14) (14)
Red Red
(15) (15)
Red Red
(16) (16)
Red Red
(18) (18)
Red Red
(19) (19)
Red Red
(20) (20)
Red Red
(21) (21)
Red Red
(22) (22)
Red Red
(23) (23)
P/N 960-100925R_Rev. A {EDP #186705}
Transaction Based Validator Integration Guide
Table 21 Standard LED Error Codes (Continued)
Error
Input Voltage is too low.
[Solution] Check that the following parts are properly assembled and/or Harness
Voltage Problem connected. Clean or adjust the following parts and Sensors.
[Relative Parts] Power Supply Unit.
If the error is not resolved, change the above related part or parts.
Sensors detect Banknotes remain in path, or none existed during an abnormal
timing condition.
[Solution] Check that the following parts are properly assembled and/or Harness
Fraud Detection
connected. Clean or adjust the following parts and Sensors.
[Relative Parts] Line Sensor, Feed-out Sensor, Box Feed-out Sensor, Side Sensor.
If the error is not resolved, change the above related part or parts.
While communicating with each device on the CPU Board, Sensors detect an
abnormal operating condition.
[Solution] Check that the following parts are properly assembled and/or Harness
I2C Access Error
connected. Clean or adjust the following parts and Sensors.
[Relative Parts] CPU Board.
If the error is not resolved, change the above related part or parts.
SDRAM reading and/or writing is not properly performed.
[Solution] Check that the following parts are properly assembled and/or Harness
connected. Clean or adjust the following parts and Sensors.
SDRAM Error
[Relative Parts] CPU Board.
If the error is not resolved, change the above related part or parts.
EEPROM reading is not properly performed.
[Solution] Check that the following parts are properly assembled and/or Harness
EEPROM Reading
connected. Clean or adjust the following parts and Sensors.
Error
[Relative Parts] CPU Board.
If the error is not resolved, change the above related part or parts.
EEPROM writing is not properly performed.
[Solution] Check that the following parts are properly assembled and/or Harness
EEPROM Writing
connected. Clean or adjust the following parts and Sensors.
Error
[Relative Parts] CPU Board.
If the error is not resolved, change the above related part or parts.
While operating the Feed Motor, Sensors detect an over current condition.
[Solution] Check that the following parts are properly assembled and/or Harness
Feed Motor Over
connected. Clean or adjust the following parts and Sensors.
Current Problem
[Relative Parts] Feed Motor.
If the error is not resolved, change the above related part or parts.
While the Stack Motor is operating, Sensors detect an over current condition.
[Solution] Check that the following parts are properly assembled and/or Harness
Stack Motor Over
connected. Clean or adjust the following parts and Sensors.
Current Problem
[Relative Parts] Stack Motor.
If the error is not resolved, change the above related part or parts.
While the Feed Motor is operating, Sensors detect an overheating condition.
[Solution] Clean that the following parts are properly assembled and/or Harness
Feed Motor
connected. Clean or adjust the following parts and Sensors.
Overheat Problem
[Relative Parts] Feed Motor.
If the error is not resolved, change the above related part or parts.
Causes and Solutions
© 2010, Japan CashMachine Co, Limited
2 4