Table of Contents
Advertisement
6. When installing the equipment, connect the
Frame Unit to the Frame Ground of the Host
Machine.
7. Be sure to connect the Ground Wire of the Inter-
face Connector to the Chassis Frame Ground.
Mounting, Dismounting & Transportation
1. Be sure to turn the Power OFF before mounting
or removing the Unit from its permanent location.
Plugging or unplugging Connector Plugs from
their receptacles while the Power is ON may
cause damage to the Unit.
2. When reassembling a disassembled Unit Section,
ensure that each part is properly placed in its
original correct location.
3. Be sure to carry the Unit by both hands when
transporting it. Holding the Unit with one hand
may cause personal injury if the Unit accidently
becomes disassembled and falls apart.
4. Be careful not to use excessive outside pressure
on the Unit, or subject it to excessive vibration
during transportation.
5. Be careful not to exert external pressure on the
equipment without the Cash Box in place. Strong
pressure on the Frame may cause it to distort.
Preventive Maintenance
1. Be sure to turn the Power OFF before beginning a
Maintenance Procedure. The equipment produces
improper operating signals while in maintenance
mode that may cause personal injury.
2. If the Validator Section is dirty due to dust, for-
eign objects or other such debris adhering to it,
the Banknote acceptance rate will degrade. Clean
the Unit once a month to keep its performance
optimal and stable.
3. Use a soft, lint-free cloth, Cotton swab or Com-
pressed Air spray to clean dust and debris from
the Banknote transportation path.
4. Perform cleaning and maintenance regularly
when using the equipment in places where
excessive Automobile exhaust emission or
Cigarette Smoke may exist.
Caution: Do not use Alcohol, thinner or
citrus based products for cleaning any
surfaces. The Lenses can become
clouded by chemical effect that may
cause acceptance errors.
Use a lint-free cloth soaked with purified
water and wrung dry to clean the
internal surfaces and BNF Rollers only.
5. Be sure that the Guide or individual Unit Sections
are properly replaced in their correct location
following a maintenance procedure.
6. Do not redesign or disassemble the Unit. Un-
authorized use by inadequately trained personnel,
or use outside the original manufacture's intended
use for operation voids the warranty.
Banknote Fitness Requirements
1. The following Banknote types may not validate
correctly, or can cause a Banknote jam and/or
damage to the Unit's Transport path.
P/N 960-100925R_Rev. A {EDP #186705}
Transaction Based Validator Integration Guide
4
Banknotes exhibiting the conditions listed below
and illustrated in Figure 4 should be avoided:
• Having perforated or torn areas
• Having excessive folds
• Wet or damp
• Having excessive wrinkles
• Shabby/warn condition
• Adhering foreign objects and/or oil.
Damaged Banknotes
Wrinkled Banknotes
Curled Banknotes
Folded or Partial Banknotes
Figure 4 Unacceptable Banknotes
2. When inserting a bundle of Banknotes, Flip-over
and Fan-Flip the Banknotes; especially the new or
nearly new Banknotes in order to insert air in-
between them so they do not stick each other
prior to Bezel insertion (See Figure 5).
Figure 5 Fan-Flipping Banknotes
3. When inserting mixed, different sized Banknotes
into the Bezel, align one side of their rough edges
smoothly to one side of the bundle before insert-
ing them (See Figure 6).
Figure 6 Aligning Banknotes Edges
© 2010, Japan CashMachine Co, Limited
Hide quick links:
Advertisement
Table of Contents
