List Sweep Measurements - Keysight B2980 Series Programming Manual

Programming Examples

List Sweep Measurements

List Sweep Measurements
A program example of list sweep measurements is shown in Table 2-4. This
example is used to apply sweep voltage and measure current at each sweep step.
List sweep measurements can be performed by using the following commands.
Function
Selects source function
Sets list sweep output
Sets output range when starting
sweep
Sets source output value
Sets list sweep output values
Adds list sweep output values to
the end of the present setting
Specifies the list sweep start point
Asks the number of sweep points
Sets measurement function
Sets measurement range
Sets aperture time in seconds or
by using NPLC value
Selects trigger source
Sets interval of timer trigger
Sets trigger count
Sets trigger delay time
Enables/disables Ammeter input
2- 14
Command
:SOUR:FUNC:MODE VOLT
:SOUR:VOLT:MODE LIST
:SOUR:VOLT:RANG value
:SOUR:VOLT value
:SOUR:LIST:VOLT values
:SOUR:LIST:VOLT:APP values
:SOUR:LIST:VOLT:STAR start_index
:SOUR:LIST:VOLT:POIN?
[:SENS:]FUNC "func"[, "func"[, "func"]]
[:SENS:]func:RANG:AUTO <ON | OFF>
[:SENS:]func:RANG value
[:SENS:]func:APER time
[:SENS:]func:NPLC value
:TRIG<:ACQ | :TRAN | [:ALL]>:SOUR source
:TRIG<:ACQ | :TRAN | [:ALL]>:TIM time
:TRIG<:ACQ | :TRAN | [:ALL]>:COUN value
:TRIG<:ACQ | :TRAN | [:ALL]>:DEL time
:INP <ON | OFF>
Keysight B2980 Programming Guide, Ed ition 1