Sampling Measurements - Keysight B2980 Series Programming Manual

Sampling Measurements

A program example of sampling measurements is shown in Table 2-5. This example
is used to apply constant voltage and measure current six times.
Sampling measurements can be performed by using the following commands.
Function
Selects source function
Sets output range when starting
sweep
Sets source output value
Sets triggered source output value
Sets measurement function
Sets measurement range
Sets aperture time in seconds or
by using NPLC value
Selects trigger source
Sets interval of timer trigger
Sets trigger count
Sets trigger delay time
Enables/disables Ammeter input
Enables/disables Voltage Source
output
Initiates specified action
Reads result data (array data)
Keysight B2980 Programming Guide, Ed ition 1
Sampling Measurements
Command
:SOUR:FUNC:MODE VOLT
:SOUR:VOLT:RANG value
:SOUR:VOLT value
:SOUR:VOLT:TRIG value
[:SENS:]FUNC "func"[, "func"[, "func"]]
[:SENS:]func:RANG:AUTO <ON | OFF>
[:SENS:]func:RANG value
[:SENS:]func:APER time
[:SENS:]func:NPLC value
:TRIG<:ACQ | :TRAN | [:ALL]>:SOUR source
:TRIG<:ACQ | :TRAN | [:ALL]>:TIM time
:TRIG<:ACQ | :TRAN | [:ALL]>:COUN value
:TRIG<:ACQ | :TRAN | [:ALL]>:DEL time
:INP <ON | OFF>
:OUTP <ON | OFF>
:INIT<:ACQ | :TRAN | [:ALL]>
:FETC:ARR?
:FETC:ARR:type?
Programming Examples
2- 19