Table of Contents
Advertisement
8. High-pressure air systems are dangerous. DO NOT service or trouble-shoot systems with air
supply on. Be sure to bleed off any trapped air before working on components since it is
possible to have high pressures trapped in airlines and cylinders, etc.
9. Keep fingers, hands, feet, clothing, etc., out of the path of pneumatically operated components.
10 Safety glasses should be worn in equipment area.
11. Follow the safety regulations for your plant. ALWAYS USE GOOD JUDGEMENT.
Specific Requirements
1. Voltage
The system is designed for one location hookup. If the unit is equipped with a vibratory table or
power conveyors, three phase voltage will be required. The control voltage will be maintained
through a step-down transformer in the control panel. If the unit is only equipped with the GSE
controller, 110 Volt, single phase is required.
2. Air Requirements
The system is designed for one location hookup. The maximum air requirements when all
options are selected are approximately 3.9 CFM @ 80 PSI per bag cycle.
3. Solenoids / Pneumatics
All pneumatic components (air valves & cylinders) are self-lubricating and additional lubricated
air is not required. If lubricated air is used then lubricated air must be used for the life of all the
cylinders.
.
13
Advertisement
Table of Contents
