Powering The Access Point; Power Feature Matrix; Connecting A Power Injector - Cisco Catalyst IW9165D Hardware Installation Manual

Powering the Access Point

Powering the Access Point
The AP supports these power sources:
• DC power – 24–48 VDC
• Power-over-Ethernet (PoE)
The AP can be powered via the PoE input from an inline power injector or a suitably powered switch port.
Depending on the configuration and regulatory domain, the required power for full operation is 802.3at (PoE+)
or 24 - 48 VDC.
For more information, see

Power Feature Matrix

The following table provides the AP power feature matrix.
Table 6: Cisco Catalyst IW9165D Heavy Duty Access Point Power Feature Matrix
Power Input
24-48V
802.3at
802.3af

Connecting a Power Injector

The AP supports the following power injector:
Table 7: Supporting Power Injectors
Power Source
IW-PWRINJ-60RGDMG=
The power injector provides DC voltage to the AP over the Ethernet cable and supports a total end-to-end
Ethernet cable length of 100 m (328 ft) from the switch to the AP.
When an optional power injector powers your AP, follow these steps to complete the installation:
Step 1
Before applying PoE to the AP, ensure that the AP is grounded (see
Step 2
Connect a CAT5e or better Ethernet cable from your wired LAN network to the power injector.
To reduce the risk of fire, use only No. 24 AWG or larger telecommunication line cord. Statement 1023
Warning
Note The installer is responsible for ensuring that powering the AP from this type of power injector is allowed by
local and/or national safety and telecommunications equipment standards.
Cisco Catalyst IW9165D Heavy Duty Access Point Hardware Installation Guide
28
Power Sources, on page 7
5G Radio 5G/6G Radio
2x2 2x2
2x2 2x2
1x1 1x1
and Power Feature Matrix, on page
GNSS mGig Eth
Yes max 2.5G
Yes max 2.5G
Yes max 1G
Description
60W rated outdoor power injector, 5GE
Grounding the Access Point, on page
Installation Overview
28.
RJ45 1G
Yes
Yes
No
26).