Powering The Access Point - Cisco CW91641-A Hardware Installation Manual

Installation Overview
http://www.cisco.com/c/en/us/td/docs/wireless/access_point/mounting/guide/apmount.html.
The standard mounting hardware supported by the AP is listed in the following table.
Table 4: Brackets and Clips for Mounting the AP
Mounting Type
Brackets
Clips
Desk mount
1
2
3
When mounting the AP in areas where there is a possibility of the AP being knocked off the mounting bracket,
use the lock hasp at the back of the AP to lock it to the bracket.

Powering the Access Point

Caution
The AP can be powered only through PoE using the following:
• 802.3bt: Any 802.3bt-compliant switch port or Cisco Power Injector AIR-PWRINJ7=
• Cisco Universal PoE (Cisco UPoE)
• 802.3at (PoE+): Any 802.3at-compliant (30.0 W) switch port
• 802.3af: Any 802.3af-compliant (15.4 W) switch port
123
Mount the AP using no less than four screw holes on a bracket.
AIR-AP-BRACKET-3 is not compatible for use with Cisco Catalyst Wireless 9164I access points.
You can also use the in-tile mounting options available from third parties. For more information, see
the access point data sheet.
Ensure that the AP is powered using a Underwriters' Laboratories-compliant (UL-compliant) PoE power
source. You must connect the unit only to the PoE network, without routing to the outside plant.
Cisco Catalyst 9164 Series Wi-Fi 6E Access Point Hardware Installation Guide
Part Number
AIR-AP-BRACKET-1
AIR-AP-BRACKET-2
AIR-AP-T-RAIL-R
AIR-AP-T-RAIL-F
AIR-CHNL-ADAPTER
—
Powering the Access Point
Description
Low-profile bracket: Used for
ceiling-mount installations. (This
is the default option.)
Universal bracket: Used for wall or
electrical box installations.
Ceiling grid clip (recessed
mounting). (This is the default
option.)
Ceiling grid clip (flush mounting).
Optional adapter for channel-rail
ceiling grid profile.
Desk mount rubber feet using screw
size 8-32x.28"
19