Branch Circuit Rating (Lpc Only); Ac Line Qualify Time (Lpc Only); Can Instance And Baud Rate - Sensata Dimensions 12LP15 Owner's Manual

Dc to ac power inverter/charger pure sine wave output

Hide thumbs Also See for Dimensions 12LP15:

Table of Contents

AGM the blink code is Amber-Green-Green. For Gel the blink code is Amber-Green-

Green-Green.

Branch Circuit Rating (LPC only)

The branch circuit rating ("BCR") can be set to 0, 5, 10, 15, or 20A. If set to 0A, the

charger will not enable. Bypass will still be available. The default factory setting is 15A.

The BCR may be changed at the factory or by the CAN configuration interface.

The AC line qualification time can be set to any value between 5 and 60 seconds, in 1

second increments. This default setting is 30 seconds. This setting adjusts the time that

it takes for the charger and bypass to start once qualified AC power has been applied to

the charger input. This setting may be changed at the factory or with the CAN

configuration interface.

The CAN instance (address) can be changed from 1 – 13. This is useful if there are

multiple inverters being used on the same CAN network. Multiple inverters should not

share the same CAN instance. The Baud Rate may be changed between 250k and 500k.

The default settings for the inverter are Instance 1 and Baud Rate 250k. These values

may be changed at the factory or by the CAN configuration interface.

NOTE: In the highly unlikely chance that an internal error occurs to the memory of

the inverter/charger, the inverter/charger configuration will reset to the

12LPC15 standard. All settings will revert to the standard default

configuration, except the battery setting will be set to GEL.

122221 12LPC15 Manual Rev A.docx

Table of Contents

Dimensions 12lpc15