Inverter Configuration Tool - Sensata Dimensions 12LP15 Owner's Manual

INVERTER CONFIGURATION TOOL

The inverter/charger settings described in the previous section may be adjusted with a
CAN interface kit, which is sold separately. The kit consists of a Kvaser CAN interface
which connects to a USB port on a laptop, a DB9 to RJ45 adapter, a terminating resistor,
and a Windows PC program that can be installed on a x32 or x64 machine.
After the software has been properly installed, the Kvaser device may be plugged into
the computer. The first time the Kvaser is connected, the computer may need to
download the appropriate Kvaser drivers from the Kvaser website. Once the Kvaser
device is ready to be used, the terminating resistor and DB9 to RJ45 adapter may be
connected to the inverter CAN port.
Once the inverter is turned on, the Configuration Interface may be opened on the
laptop. Once open, the tool will automatically look for a CAN device on the network.
Once found, it will automatically connect and display the current inverter/charger
settings.
Note: Only one CAN enabled inverter can be connected at a time. To make a settings
change, click on a parameter and the available options will appear in a drop-down
menu. Once a setting is changed, the change is immediately set into the inverter's
memory. After making all the settings changes it is prudent to turn the inverter
off for 30 seconds and then turn it back on for the setting changes to take effect.
The settings may be saved to a configuration file. The configuration file maybe used to
program any additional units that are to be programmed with the same settings.
122221 12LPC15 Manual Rev A.docx
20