IDTECK iTDC Troubleshooting Manual page 25

2) Communication does not work.
② Check if the Communication Default Settings are Configured Correctly
: Check if Communication Speed, Board ID, Com Port Setting are configured correctly.
 Baud Rate must be configured in same value as configured in the controller in same loop.
 Please note that the Com Port may vary according to different PCs.
Com Port
Baud Rate
[System] >> [Loop Definition]
※ How to Check Communication Port
(Serial Port Expansion using the USB Cable)
: START  SET UP  CONTROL PANEL  SYSTEM
ICON
 Go to HARDWARE TAB and click DEVICE
MANAGER
 Out of the Port List, Select the Port Number
(i.e. COM1) for USB Serial Cable
2011 Jan IDTECK. © All rights reserved
25
.