RadioLink T8FB Instruction Manual page 2

Fhss compatible with helicopter/fixed wing/multicopter/car/boat
Hide thumbs Also See for T8FB:
Table of Contents

Advertisement

Thank you for purchasing Radiolink 2.4 GHz remote control system T8FB .
To fully enjoy the benefits of this product and ensure safety, please read the manual carefully and set up
the device as instructed steps.
If any problems found during the operation process, either way listed below can be used as online tech
support.
1. Send mails to
after_service@radioLink.com.cn
answer your question at the earliest.
2. PM us on our Facebook page or leave comments on our Youtube page
3. If the product is purchased from RadioLink AliExpress Global or Amazon U.S , you can contact after-
sales service directly.
4. If the product is purchased from the local distributor, you can also ask them for support and repair as
prefer.
All manuals and firmwares are available on RadioLink official website
are uploaded. Or follow our Facebook and Youtube homepage to stay tuned with our latest news.
SAFETY PRECAUTIONS
Never operate your model during adverse weather conditions. Poor visibility can cause disorientation and
loss of control of your model.
Never use this product in a crowd and illegal area.
Always ensure the trim levers at 0 and battery properly charged before connecting the receiver.
Always check all servos and their connections prior to each run.
Always be sure about turning off the receiver before the transmitter.
WARNING
This product is not a toy and is NOT suitable for children under the age of 18. Adults should keep the
product out of the reach of children and exercise caution when operating this product in the presence of
children.
Water or moisture may enter the transmitter inside through gaps in the antenna or joystick and cause
model instability, even out of control. If running in the wet weather(such as game) is inevitable, always use
plastic bags or waterproof cloth to cover the transmitter.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference, and
1
This device must accept any interference received, including interference that may cause undesired
2
operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
or
after_service1@radioLink.com.cn
www.radiolink.com
RadioLink Electronic Ltd
www.radiolink.com
and we will
and more tutorials

Advertisement

Table of Contents
loading

Table of Contents