RadioLink T8FB Instruction Manual page 16

"MIX" (mix control) first and choose an auxilary switch to flip and set the max/min range value to its
correspoding channel by toggling. In the example picture shown above: When flip SWA upward and toggle
CH1 stick , it means the max/min range of CH1 can be +100 and -100. If the UP value modified to 50, it
means the max range can only be +50/-50 when toggle CH1 up and down. 'DOWN" means when flip SWA
downward, the max/min value of CH1 is +100/-100.
ATTITUDE: Turn on "CH"first and select the preferred channel. The values behind each channel means
different control percentage output different control signals.
Pilots can set 6 different modes (NORMAL, ATTI, GPS, HOVER, F/S and AUX) by adjusting the related rates.
Every mode has different rates to get a unique signal. NORMAL mode preset 0%, ATTI 50%, GPS 100%,
HOVER 25%, F/S 75% and AUX 50%. 0% means a output signal 1ms, and 100% means 2ms.
Note If flight controller used is RadioLink PIX or Mini Pix, no setup needed here by default.
ELEVON: Turn on "MIX" (mix control) first, adjust the aileron distance and allow aileron differential.
ADJUSTABILITY:
• CH1 and CH2 are required.
• Independently adjustable aileron travel allows aileron differential.
• Independently adjustable elevator travel allows for differences in up vs. down travel.
• The separate ELEVON settings for each condition can be set. (GLIDER only)
V-TAIL: This function is used on the V-tail aircraft.
V-TAIL mixing is used with v-tail aircraft so that both elevator and rudder functions are combined for the two
tail surfaces. Both elevator and rudder travel can be adjusted independently on each surface.
ADJUSTABILITY:
• CH2 and CH4 are required.
• Independently adjustable travel allows for differences in servo travels.
• Rudder differential is not available. To create rudder differential, set RUD1 and 2 to 0, then use two
programmable mixes, RUD-ELE and RUD-RUD, setting different percentages for up and down. These are
new rudder travels. Turn the trim and link off, switch assignment null so rudder won't be accidentally turned
off.
Note
V-TAIL function and ELEVON/AILEVATOR mix functions can't be activated at the same time. If both of these
functions are activated, an error message will be displayed and you must inactivate the last function prior to
activating ELEVON.
Make sure to move the elevator and rudder sticks regularly while checking the servo motions. If a large travel
value is set, when the sticks are moved at the same time, the controls may mutually disturb or run out of
travel. Decrease the travel until no disturbance occurs.
:
4) "SYSTEM" There are three parameters to set: "AUX-CH" "PROG.MIX1" "PROG.MIX2"
AUX-CH
CH5/6/7/8 Auxilary channels Ch5 to Ch8 can be personalized to different switches
TX Alarm
When the transmitter voltage is lower than the value set, T8FB will make D sound to warn.
STK-MODE by default
1 is throttle at right while 2 is throttle at left. 3 is throttle at right for toys while 4 is throttle at left for toys.
13
RadioLink Electronic Ltd
www.radiolink.com