Part 1 Introduction Of T8Fb System; T8Fb Introduction - RadioLink T8FB Instruction Manual

1.1 T8FB Introduction

1) One two-way switch, one three-way switch, two VR switches, four trimmers, two sticks.
2) The picture below is mode1, SwB is default to control CH5, VrB is default to control CH6, SwA is
default to control CH7 and VrA is default to control CH8.
Universal JST battery connector supports multiple batteries, include 4pcs AA batteries or 2S to 4S
3)
LiPo battery.
4) Defaulted low battery alarm voltage can automatically match 2S and 3S LiPo battery or 4pcs AA
batteries, can setting in the T8FB configure software.
3S LiPo battery: default low voltage alarm to 11.0V automatically after detection, you can setup low battery
voltage alarm from 10.0V to 12.5V.
2S LiPo battery:
default low voltage alarm to 7.3V automatically after detection, you can setup low battery
voltage alarm from 7.0V to 8.9V.
4 pcs AA Ni-MH battery:
battery voltage alarm from 4.0V to 6.4V.

Part 1 INTRODUCTION OF T8FB SYSTEM

default low voltage alarm to 5.0V automatically after detection, you can setup low
（MODE 1）
1
RadioLink Electronic Ltd
www.radiolink.com