Parametrisation - Festo CPX Series Manual

2. Commissioning
2.8

Parametrisation

Festo P.BE−CPX−PN IO−EN en 1008b
You can individually set the behaviour of the CPX terminal
through parametrisation. We distinguish between the
following parametrisation variants:
System parametrisation, e.g. deactivating error messages
etc.
Module parametrisation (module−specific and
channel−specific), e.g. module monitoring, settings for
errors, adjustment of debouncing times for the inputs,
etc.
Parametrisation of the diagnostics memory
A detailed description of the individual parameters as well as
basic information about application can be found in the CPX
system description (P.BE−CPX−SYS−...).
Parameter lists for the various CPX modules can be found in
the corresponding descriptions for the modules
(P.BE−CPX−EA−..., P.BE−CPX−AX−..., P.BE−CPX−CP−... etc.).
Note Module parameter in the operating mode FSU
In the Fast Start−up" (FSU) operating mode, the module
parameters cannot be set through the control software
(exception: VTSA−D pneumatics interface).
Use the Festo Maintenance Tool (FMT) or the handheld
(MMI) to make the required settings.
System parameters can be set in all operating modes, also
in the FSU operating mode, using the control software.
2−51