Festo CPX Series Manual page 102

2. Commissioning
1
Fig. 2/21: Setting module parameters with Siemens STEP 7
2−56
Setting module parameters
1. Start the PROFINET hardware configuration in your
configuration and programming software (e.g. HW Config
in Siemens STEP 7).
3
2. Double click in the configuration table on the designation
of the module you would like to parametrise
( 1 in Fig. 2/21). The Properties ..." dialogue window is
displayed.
3. Click on the value (Value") of the parameter that you
would like to change. A list with the possible values will
be opened 2.
2
Festo P.BE−CPX−PN IO−EN en 1008b