Fig 4.1 Battery Replacement - Vinten pro-touch Pro-10 System Maintenance Manual

Contents
4.5 Check for ageing and cracking of the rubber foot securing straps on the spreader and renew if
necessary.
5 No further routine maintenance is required.
Battery replacement
6 The battery illuminates the level bubble (10) when the switch (13) is pressed. The level bubble remains
lit for approximately 15 seconds.
7 The battery should be replaced yearly or whenever the illumination is considered inadequate.
8 To replace the battery
8.1 Tilt the head backwards to allow access to the battery cover
8.2 Push down on the top of the battery cover
8.3 Pull the battery
8.4 Push the replacement battery into the battery compartment, observing the correct polarity, as
indicated on the inside of the compartment
8.5 Refit the battery cover (16).
8.6 Press the switch (13) and ensure that the level bubble (10) is lit for approximately 15 seconds.
(16)
(Fig 4.1):
(16.1) out of the battery compartment.

Fig 4.1 Battery replacement

First
Page
(16) and apply the tilt brake (4).
(16) and pull forward.
Previous Next Previous
Page Page View
(4)
(16.1)
20