Battery Replacement - Vinten Protouch PRO-6 HDV Operator's Manual

Battery replacement

The battery illuminates the level bubble
remains lit for approximately 15 seconds, or until the switch
The battery should be replaced yearly or when the switch
tery level.
To replace the battery (Fig
Apply the pan brake
tabs (12.1) together from the underside of the head. The illumination module will then lift
out of the head.
Push the battery (12.2)
(pen).
Push the replacement battery into the illumination module, observing the correct polarity.
Refit the illumination module
Press the switch (13)
onds.
(13)
(12)
BATTERY TYPE
3v, CR1220
(12.2)
(11) when the switch
7):
(15) and remove the illumination module
out of the illumination module from behind using a suitable pointer
(12) into the head. Push downward until in 'snaps' into place.
and ensure that the level bubble
(12.1)
Fig 7 Battery replacement
(13) is pressed. The level bubble
(13) is pressed a second time.
(13) illuminates red to warn of a low bat-
(12) by pressing the retaining
(11) is lit for approximately 15 sec-
(15) (11)
Back
23