Vinten pro-touch Pro-10 System Maintenance Manual page 23

Contents
(20.2)
(20.1)
Fig 4.3 'Pozi-Loc' tripod leg - top clamp adjustment
Bottom clamp
15 The design of the bottom clamp changed at tripod Serial No. 03515. Identify version as follows
4.4):
15.1 Turn the clamp knob
15.2 Using a suitable instrument, such as a flat-bladed screwdriver, carefully remove the knob cap
(20.6).
15.3 Remove the retaining screw
15.4 Examine the shaft (20.3).
15.4.1 Earlier clamps have a smooth shaft and are fitted with locking and adjusting
grubscrews. Loctite is used on these screws.
15.4.2 Later clamps have a groove machined in the shaft and are fitted with a single, longer,
adjusting grubscrew, retained by a locking thread insert.
(20) to Position 1 (fully 'on').
(20.5) and washer
First
Page
(20.4) and pull off the clamp knob (20).
Previous Next Previous
Page Page View
(20)
(Fig
23