Maintenance; General; Routine Maintenance; Cleaning - Vinten vector 430 Operator's Manual

Pan and tilt head
Hide thumbs Also See for vector 430:
Table of Contents

Advertisement

Vector 430 pan and tilt head

Maintenance

General

The Vector 430 pan and tilt head is robustly made to high engineering standards and little
attention is required to maintain serviceability save regular cleaning.

Routine maintenance

Replace the batteries whenever the low battery indicator flashes on the digital numeric display
(3).
During use, check the following:
Check the effectiveness of the pan (7) and tilt (6) brakes. Reset as necessary.
Check the effectiveness of the slide plate clamp (14). Reset as necessary.
Check the operation of the balance mechanism digital numeric display (3) and the
illumination of the LEDs, level bubble (9) and drag adjustment knobs (11,12). Replace
the batteries if necessary.
No further routine maintenance is required.

Cleaning

During normal use the only cleaning required should be a regular wipe over with a lint-free cloth.
Dirt accumulated during storage or periods of disuse may be removed with a semi-stiff brush.
Particular attention should be paid to the wedge location faces of the wedge adaptor.
NOTE: Use only detergent-based cleaners. DO NOT use solvent- or oil-based
cleaners, abrasives or wire brushes to remove accumulations of dirt as these
damage the protective surfaces
Use out-of-doors under adverse conditions may require special attention and the head should
be covered when not in use. Salt spray should be washed off using fresh water at the earliest
opportunity. Sand and dirt act as an abrasive and should be removed using a semi-stiff brush or
a vacuum cleaner.

Battery replacement

The head has three batteries powering the digital numeric display (3) and illuminate the level
bubble (9) and the scales on the drag adjustment knobs (11, 12). Batteries should be replaced
whenever the low battery indicator flashes on the digital numeric display (3). The camera system
must be removed and the head dismounted from the pedestal or tripod to access the battery
compartment located under the head,
NOTE: Removal of the batteries will not affect the calibration of the balance
mechanism display.
20

Advertisement

Table of Contents
loading

Table of Contents