Contents
Contents
General. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Assembly
Tripod and spreader . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Pan and tilt head . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Mounting the camera . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Pan and tilt brakes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
Pan and tilt drag . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
General
1
To identify components, please refer to
Assembly
2
If not already done, assemble the system as follows:
Tripod and spreader
3
Lift the tripod out of the case using the finger holes just below the top clamps.
4
Release the leg tie strap
5
Secure the spreader to the tripod feet with the rubber straps (23).
NOTE:
Once assembled, keep the spreader attached to the tripod
6
Adjust the operating height by undoing the leg clamps
height. Adjust the spreader
7
Tighten the clamps
8
In adverse conditions secure the tripod using the tie-down hook (26), or suspend a weight from the
hook.
WARNING!: Use care when the tripod is fully extended and the floor spreader is in the
closed position, as stability will be reduced.
Section 2
Operation
Fig 1.1
(24)
and spread the legs.
(22)
if necessary.
(20)
until an audible click is heard and the knob is in the horizontal, locked position.
First
Page
and
Fig
1.2.
(20)
and pulling the tripod up to the desired
Previous
Next
Previous
Page
Page
View
Para
15