Vinten pro-touch Pro-10 System Maintenance Manual page 25

Contents
16.5 Back off the adjusting grubscrew
16.6 Turn the clamp knob
16.7 Replace and tighten the locking grubscrew (20.8), using Loctite 221 and allow 15 minutes for the
Loctite to set.
16.8 Secure the clamp knob
(20.6).
17 Adjust a later clamp as follows
17.1 Replace the clamp knob
17.2 Using a 2.5 mm hexagonal wrench, slacken the grubscrew
under its own weight.
17.3 With the knob still in Position 2, slide the leg in and out and gradually tighten the grubscrew
(20.9) until the clamp begins to grip.
17.4 Back off the grubscrew
17.5 Secure the clamp knob
(20.6).
(20.7) by a quarter-turn (90°).
(20) to Position 1 (fully 'on').
(20) with the washer (20.4)
(Fig 4.4):
(20) and rotate to position 2.
(20.9) by a quarter-turn (90°).
(20) with the washer (20.4)
First Previous
Page Page
and retaining screw (20.5). Refit the knob cap
(20.9) until the leg is free to move
and retaining screw (20.5). Refit the knob cap
Next Previous
Page View
25