Routine Maintenance; Level Bubble Illumination Unit Battery Replacement - Vinten Vector 750 Operator's Manual

(15)
(5)

Routine maintenance

Level bubble illumination unit battery replacement

The level bubble on the Vector 750 pan and tilt head is illuminated by a battery-powered light-emit-
ting diode (LED). A time-delay circuit initiated by a switch controls the LED. The battery should be
replaced at yearly intervals or whenever the illumination is considered inadequate.
NOTE: Dependent on the type of mounting, it may be necessary to remove the head
from the mounting for access to the battery compartment.
To install or replace the battery:
Remove three screws
head.
Install or replace the battery (30), pushing the connector
Position the battery in the battery compartment, ensuring that the wiring is not trapped.
Refit the battery cover plate (32), ensuring battery locates in cover plate. Secure with three
screws (29).
Press the switch
Fig 6 Cleaning the horizontal tracks
(29) which secure the battery compartment cover plate
(7) and ensure the lamp is lit for approximately 15-seconds.
(28)
(31) onto the battery terminals.
Back
(25)
(26)
(2*)
(32) to the
20