Documentation; Startup - Siemens SINUMERIK 840D sl Commissioning Manual

1.3

Documentation

You require the following documentation to install and start up the SINUMERIK 840D sl:
References
Equipment Manual and Networking
SINUMERIK 840D sl Equipment Manual
CNC Commissioning Manual: NCK, PLC, Drive
Function Manual Basic Functions
List Manual, Lists (Book1)
Diagnostics Manual
Operating Manual HMI-Embedded
CNC Commissioning Manual: ShopTurn
CNC Commissioning Manual: ShopMill
1.4

Startup

Note
Before a cold restart all USB devices must be removed from the TCU and not connected
again until commissioning has been completed!
1. Insert the CompactFlash Card containing the HMI-Embedded software into the slot
2. Now switch on the power supply. The NCU starts up automatically.
For additional information about booting is provided in the following documentation:
References
CNC Commissioning Manual: NCK, PLC, Drive
Commissioning HMI-Embedded (IM2)
Commissioning Manual, 01/2008, 6FC5397-8CP10-1BA0
marked "CF" (interface X109) before switching on the NCU.
By default, you will be in the "Machine" operating area, "Jog" mode after commissioning
and the "Reference point approach" window will be active.
Introduction
1.3 Documentation
9