Hiding Machine Axes - Siemens SINUMERIK 840D sl Commissioning Manual

Functions
3.14 Zero point shift
Scratching
Scratching with system frame
G500 active
G500 not active
Only select the tool located in the spindle.
If there is no tool in the spindle, you can choose any tool you want.
Scratching without system frame
G500 active
G500 not active
You can select any tool you wish.
3.14.4

Hiding machine axes

General
You can hide axes in the "Machine" area using the channel-specific machine data
MD20098 $MC_DISPLAY_AXIS. All axes are displayed by default. The following settings
can be made:
Bit
16 = 1
16 = 0
17
18 = 1
18 = 0
19 = 1
19 = 0
42
The values are written to the system frame
The values are written in the currently active frame.
(settable frames reset)
The values are written to the set basic frame depending on the entry in
the display machine data.
MD9245 $MM_ MA_PRESET_FRAMEIDX = Index of the basic frame
The values are written in the currently active frame.
Display the machine axis in the actual-value windows (default setting).
Hide the machine axis in the actual-value windows.
n.c.
Display the machine axis in the base offset window (default).
Hide the machine axis in the base offset window.
Display the machine axis in the handwheel selection window (default).
Hide the machine axis in the handwheel selection window.
Commissioning HMI-Embedded (IM2)
Commissioning Manual, 01/2008, 6FC5397-8CP10-1BA0