Outputting The Acknowledgement Icon For Plc Alarm; Alarm Display - Siemens SINUMERIK 840D sl Commissioning Manual

Setting via the user interface of HMI-Embedded
Please proceed as follows:
1. Open a program for editing in the "Program" operating area.
2. Press the "Settings" horizontal softkey and the "Set Editor" vertical softkey to obtain the
3.5

Outputting the acknowledgement icon for PLC alarm

Using the display machine data MD9055 $MM_PLC_ALARM_PICTURE activate or
deactivate the following icons:
● Value: -1 no icon display
● Value: 0 Icon labeled "PLC" is displayed.
● Value: 1 "Cancel" icon is displayed.
This functionality refers only to PLC alarms, not to PLC messages
3.6

Alarm display

If several alarms are pending at the same time, only the last alarm is displayed in the alarm
and message line. If you want to display the pending NCK, PLC or HMI alarms alternatively,
you can set this in the display machine data MD9056 $MM_ALARM_ROTATION_CYCLE.
The following settings can be made:
< 500:
500 – 10000:
If a valid display duration is set, each alarm is displayed for this time before being replaced
by the next alarm.
Messages will not be displayed alternatively.
Commissioning HMI-Embedded (IM2)
Commissioning Manual, 01/2008, 6FC5397-8CP10-1BA0
setting screen form.
You can mark the following functions in the field with "yes".
– Release new programs
– Hide LF in the program
– Display hidden lines in the program
– Enable active programs for editing.
– Special handling for moldmaking file size specification in kBytes
No change of the alarm display, only the last alarm is displayed
Display duration of an alarm in milliseconds
3.5 Outputting the acknowledgement icon for PLC alarm
Functions
35