Table of Contents
Advertisement
IPT-HH20
Operation
7
Operation
7.1
Read data
Read/Write
/
Storage
Settings
Applications
About
The Handheld cannot read the data stored on a data carrier until you select the correct setting
for the data carrier type, known as the Tag type.
The read data is saved in the Handheld or sent to the computer depending on the setting
Settings > Send/Log (see chapter 6.3).
If you wish to add a time stamp to the read data, activate the menu entry ON in the Settings >
Time stamp menu.
Address
In the data input field of the Address menu entry, you have the option of changing the start
address.
Start addresses specify the location of the individual data blocks on data carriers. You can read
out specific data blocks and transfer data by changing the start address.
Defining a start address
Define the start address as follows:
1.
Select Address.
2.
Enter the start address using the input keys.
3.
Press the left softkey (
Setting the number of blocks
The number of blocks determines how many data blocks the Handheld reads from the data
carrier and how many data blocks can be written to the data carrier. Each block corresponds to
4 bytes.
1.
Select Read/Write > Data read > No. blocks.
2.
Refer to the table to calculate how many blocks you require to enter the relevant data.
3.
Press the CLEAR input key (
4.
Enter the number of blocks using the input keys.
5.
Press the left softkey (
32
Data read
Data write
Data copy
Read fixcode
Write fixcode
Read register
) to confirm your entry.
) to delete the quantity already entered.
) to conform your entry.
Address
No. blocks
Data
Options
write
ESC
Advertisement
Table of Contents
