Pepperl+Fuchs IPT-HH20 Manual page 105

IPT-HH20
Command reference
Single write fix code (SX)
Command:
Response:
Only possible with data carrier types IPC11 and IPC14.
Only one attempt is made to write a fix code. The specified length of the fix code is always 5
bytes
Single get configuration (SG)
Command:
Response:
Only possible with data carrier types IPC03 and IPC12.
Only one attempt is made to read a word in the configuration area ("protection word" or "control
word") from address <ConfAddr>.
Single write configuration (SC)
Command:
Response:
Only one attempt is made to write a word to the configuration area ("protection word" or "control
word") from address <ConfAddr>.
Password mode must be activated in the read head to write to the configuration area.
Fill Data Carrier (S#)
Command:
Response:
The data carrier is filled with <WordNum> data blocks described by fill signs <FillSign> from the
specified block address <WordAddr>.
Get State (GS)
Command:
Response:
This command is used to read out permanently stored read/write head settings.
SX <FixType> <FixLen> <Data>
<Status>
SG<ConfAddr>
<Status><Data>
SC<ConfAddr><Data>
<Status>
S#<WordAddr><WordNum><FillSign>
<Status>
GS
TT: <TagType>, TO:<Timeout>,
BD:<Baud>
105