Table of Contents
Advertisement
IPT-HH20
Installation
Fitting a handle with cable connection
Fit the handle to the Handheld as follows:
1.
Remove the battery from the battery compartment of the Handheld if necessary.
2.
Carefully pull the rear, flexible part of the handle attached to the plug downwards.
3.
Attach the cable connection socket on the Handheld to the plug on the handle.
4.
Slide the plastic tab on the battery into the corresponding recess on the Handheld.
The Handheld is now fitted to the handle.
5.
Push down the Handheld carefully until the locking device on the Handheld engages in the
handle.
6.
Connect the interface cable to the cable connection socket underneath the handle.
The Handheld is now ready for operation.
Fitting a handle with integrated storage battery
A handle with integrated battery is also available for this Handheld as an optional accessory. Fit
the handle to the Handheld as follows:
1.
Remove the battery from the battery compartment of the Handheld if necessary.
2.
Slide the plastic tab on the battery into the corresponding recess on the Handheld.
3.
Push down the Handheld carefully until the locking device on the Handheld engages in the
handle.
The Handheld is now fitted to the handle.
22
Advertisement
Table of Contents
