Table of Contents
Advertisement
IPT-HH20
Commissioning
6.3.4
Cable operation: USB
Adjusting the USB interface settings on the Handheld
Adjust the settings for the USB communication interface on the Handheld as follows:
1.
Select Settings > Communication
2.
Activate the interface USB.
The USB submenu opens.
3.
Press the Enter navigation key (
4.
Press the left softkey (
The interface is now activated.
5.
Press the right softkey (
Tip
Further information on interface settings see chapter 9.3.8
Connecting the interface cable to the Handheld
To connect the interface cable to the Handheld, proceed as follows:
1.
Turn the 8-pin DIN plug so that the arrows on the plug are pointing downwards.
2.
Hold the Handheld in your hand with the controls facing upwards.
3.
Insert the plug into the corresponding cable connection socket on the Handheld.
4.
Press the plug firmly into the cable connection socket until the locking device audibly
engages.
The interface cable is now connected to the Handheld.
Note!
Connection cable with fitted grip
If you have mounted the Handheld to the optional grip, connect the interface cable to the cable
connection socket on the grip.
Connecting the Handheld to the computer via the USB interface cable
Connect the Handheld to the computer as follows:
Insert the USB plug on the interface cable into a free USB port on the computer. It does not
matter whether the computer is switched on or off.
The Handheld switches on automatically once you have connected it to the computer. The
symbols
30
) to activate the desired mode.
and
are displayed in the toolbar.
) to confirm your entries.
) to exit the menu.
Advertisement
Table of Contents
