Table of Contents
Advertisement
IPT-HH20
Installation
3.
Push the locking device upwards and push in the battery.
4.
Push the battery in the Handheld, hold in position and release the locking device so that
the battery engages.
Charging battery
Charge the battery as follows:
1.
Connect the Handheld, including battery, to an interface cable.
2.
Connect the interface cable to the switched-on computer.
When the Handheld is switched on, the symbols displayed in the toolbar indicate the
charging status of the Handheld. Overviewview table "Symbols in the toolbar" on page 13
Note!
If you are operating the handheld via an RS 232 interface, connect the RS 232 interface power
supply unit to the socket to charge the battery.
Note!
Completely discharged storage batteries
If the storage battery is completely discharged, you will have to wait at least 10 minutes before
the Handheld is ready for operation again.
20
Advertisement
Table of Contents
